HP LaserJet Pro CP1525nw Color Printer - Manual (Page 40)

Install software for Mac computers on a wireless network
Before installing the product software, make sure the product is not connected to the network using a
network cable.
If your wireless router does not support Wi-Fi Protected Setup (WPS), obtain the wireless router network
settings from your system administrator, or complete the following tasks:
● Obtain the wireless network name or service set identifier (SSID).
● Determine the security password or encryption key for the wireless network.
Connect the product to a wireless network using WPS
If your wireless router supports Wi-Fi Protected Setup (WPS), this is the simplest way to set up the
product on a wireless network.
1. Press the WPS button on your wireless router.
2. Press and hold the Wireless button on the product control panel for two seconds. Release the
button when the wireless light starts blinking.
3. Wait up to two minutes while the product establishes a network connection with the wireless router.
NOTE: If this method is not successful, try using the wireless network using USB cable method.
Connect the product to a wireless network using WPS by using the control panel menus
If your wireless router supports Wi-Fi Protected Setup (WPS), this is the simplest way to set up the
product on a wireless network.
1. On the front of the product, press the Wireless button. Look at the control panel display to see if
the Wireless Menu item has opened. If it has not opened, complete these steps:
a. On the control panel, press the OK button, and select the Network Setup menu.
b. Select the Wireless Menu item.
2. Select the Wi-Fi Protected Setup item.
3. Use one of these methods to complete the setup:
● Pushbutton: Select the Pushbutton option and follow the instructions on the control panel.
Establishing the wireless connection can take a few minutes.
● PIN: Select the Generate PIN option. The product generates a unique PIN, which you must
type into the wireless router's setup screen. Establishing the wireless connection can take a
few minutes.
NOTE: If this method is not successful, try using the wireless network using a USB cable method.
Connect the product to a wireless network using a USB cable
If your wireless router does not support WiFi-Protected Setup (WPS), use this method to set up the
product on a wireless network. Using a USB cable to transfer settings makes setting up a wireless
26 Chapter 4 Use the product with Mac ENWW