Copying paths from one nas port to another, Copying paths from one nas port to another” on – HP StorageWorks XP Remote Web Console Software User Manual
Page 42
42
LUN Manager for the XP128/XP1024
Copying paths from one Fibre Channel or iSCSI port to another
CAUTION:
Before performing the following steps, see ”
Restrictions on port operations
important information.
1.
In the LU Path tree, locate the port that you want to use as the copy destination and verify that LUN
security is enabled.
NOTE:
If the port icon has a key ( ), LUN security is enabled.
If LUN security is not enabled, right-click the port and select LUN Security: OFF->ON in the shortcut
menu.
2.
To copy all the LU paths defined to a host group, complete the following steps. To copy some LU paths,
.
a. Right-click a host group in the tree and select Copy. The selected host group turns green.
b. Right-click the copy destination port and select Paste.
3.
To copy some, but not all of the LU paths defined to a host group, complete the following steps. To copy
all LU paths, see
a. Select a host group in the LU Path tree.
b. In the LU Path table, select one or more LUNs to which volumes are assigned.
c. Right-click the selection and select Copy Paths in the shortcut menu. The selected LUNs turn green.
d. Double-click the copy destination port.
e. Right-click the copy destination host group and select Paste Paths.
4.
Click Apply in the LUN Manager main pane. A confirmation message appears.
5.
Click OK. The settings are applied to the disk array.
Copying paths from one NAS port to another
CAUTION:
Before performing the following steps, see ”
Restrictions on port operations
important information.
1.
Specify the LU paths to copy:
a. In the LU Path tree, double-click a NAS port (the copy source port) and select the User host group.
b. In the LU Path table, select one or more LUNs to which volumes are assigned.
NOTE:
If a volume is assigned to a LUN, the columns on the right of the LUN column are not
empty.
c. Right-click the selected LUNs and select Copy Paths. The selected LUNs turn green.
2.
Paste the LU paths:
a. In the LU Path tree, double-click the copy destination port (a NAS port) to display the User host
group below the port.
b. Right-click the User host group and select Paste Paths.
3.
Click Apply in the LUN Manager tab. A confirmation message appears.
4.
Click OK. The settings are applied to the disk array.