HP Designjet Z3100 Photo Printer series - Manual (Page 165)

The sheet stays in the printer when the print has been
completed
The printer holds the paper to allow the print to dry after printing, see Change the drying time
on page 41 . If the paper is only partially ejected after the drying time, gently pull the sheet out of the
printer. If the automatic cutter is disabled, use the Form feed and cut key on the front panel, see Feed and
cut the paper on page 42 .
The paper is cut when the print has been completed
By default the printer cuts the paper after the drying time has been completed, see Change the drying
time on page 41 . You can disable the cutter, see Turn the automatic cutter on and off on page 42 .
The cutter does not cut well
By default the printer is set to automatically cut the paper after the drying time has been completed.
However, there are some papers that cannot be cut, such as canvas or very thick paper, even when
the
Form feed and cut key is pressed.
If the cutter is turned on but not cutting correctly, check that the cutter rail is clean and clear of any
obstacles.
If the cutter is turned off, or the paper selected is canvas, the Form feed and cut key only advances the
paper. Use this key to move the print far enough out of the front of the printer, until it is convenient to
manually cut with a straight edge or scissors.
The roll is loose on the spindle
The roll may need to be replaced or reloaded. If your roll has a three-inch cardboard core, ensure the
core adaptors supplied with the printer have been installed, see
Load a roll onto the spindle
on page 27 .
A strip stays on the output tray and generates jams
If a small piece of paper (200 mm or smaller) has been cut, such as before (if new roll) and after a full-
bleed print or after the
Form feed and cut key has been pressed, the cut strip remains in the output tray.
Only when the printer is not working, reach in the tray and remove the strip.
ENWW The sheet stays in the printer when the print has been completed 155
Pa
per
is
sue
s