HP Photosmart C6280 All-in-One Printer - Manual (Page 115)

I connected the USB cable, but I am having problems using the HP All-in-One with
my computer
Cause: The USB cable was connected before the software was installed.
Connecting the USB cable before prompted can cause errors.
Solution: You must first install the software that came with the HP All-in-One before
connecting the USB cable. During installation, do not plug in the USB cable until
prompted by the onscreen instructions.
Once you have installed the software, connecting your computer to the HP All-in-One
with a USB cable is straightforward. Simply plug one end of the USB cable into the
back of your computer and the other into the back of the HP All-in-One. You can
connect to any USB port on the back of your computer.
For more information on installing the software and connecting the USB cable, see
the Setup Guide that came with the HP All-in-One.
The display shows the wrong language
Cause: You might have selected the incorrect language when setting up the HP All-
in-One.
Solution: You can change the language settings at any time from the
Preferences menu.
For more information, see:
“Set your language and country/region” on page 15
The wrong measurements are showing in menus on the display
Cause: You might have selected the incorrect country/region when setting up the
HP All-in-One. The country/region you select determines the paper sizes shown on
the display.
Chapter 14
114 Troubleshooting
T
roub
les
hoot
ing