HP XP External Storage Software - Manual (Page 81)

•
Cancel button
Cancels the settings and closes the dialog box.
•
Pop-up Menu
Right-click a row in the Configure Cross-subsystem Paths dialog box to perform the following
operations.
Table 11 Pop-up Menu in the Configure Cross-subsystem Paths dialog box
Description Pop-up menu Right-clicked area
Allows you to add cross-subsystem
paths. See
“Configuring the
Cross-subsystem Path” (page 81) .
Add WWN in the Available Paths
Allows you to delete the selected
cross-subsystem path. See
“Canceling
the Cross-subsystem Path
Configuration” (page 83)
.
Delete Selected Paths
Allows you to raise the priority of the
selected cross-subsystem path. See
“Changing the Configured
Cross-subsystem Path Priority”
(page 82)
.
Raise Priority
Allows you to lower the priority of the
selected cross-subsystem path. See
“Changing the Configured
Cross-subsystem Path Priority”
(page 82)
.
Lower Priority
Configuring the Cross-subsystem Path
You can configure the cross-subsystem path using the Configure Cross-subsystem Paths dialog box.
This section explains the procedure to add a cross-subsystem path to an existing path group. To
create a new path group and configure cross-subsystem paths, you need to operate the mapping
operation. For the procedure, see
“Mapping an External Volume Automatically” (page 67) .
To add the cross-subsystem path to an existing path group:
1. Start Remote Web Console, and open the Volume Operation window.
2. Make sure that Remote Web Console is in Modify mode.
3. Click the path group that you want to add a cross-subsystem path in the Volume Operation
tree.
4. Right-click the cross-subsystem path in Cross-subsystem Paths in the Volume Operation list.
5. Click Configure Cross-subsystem Paths in the pop-up menu.
The Configure Cross-subsystem Paths dialog box opens (see “Configure Cross-subsystem Paths
Dialog Box” (page 79) ).
6. In the Available Paths, select the following three items (see Figure 33 (page 82) ).
•
External storage system: Select the external storage system.
•
Port: Select the external port of the local storage system, which is the starting point of the
cross-subsystem path.
•
WWN: Select the WWN of the external storage system, which is the ending point of the
cross-subsystem path.
If the external storage system or the WWN that you want to choose is not displayed in the
dialog box, you can update the information by clicking Port Discovery, selecting the port that
connects to the WWN, and then clicking OK.
Setting the Cross-subsystem Paths 81