HP XP External Storage Software - Manual (Page 105)

Table 18 Information Saved when the MappedVolume Tag is Written
Content Item Column in
Spreadsheet
Layer
Information about the external storage system First Layer
Name of the vendor Vendor A
Name of the storage system Product B
Serial number of the storage system SerialNumber C
Information about the external volume Second Layer
Identifier + A
Path group number PathGroup B
External volume group number and its sequential number ExG C
Identification number of the external volume Characteristic1 D
Name of the storage system that is reported to the host by the external
volume Device E
•
Normal: This volume is an external volume.
• R-CMD: This volume is a remote command device.
Attribute F
•
Enable: Cache mode is set to Enable.
• Disable: Cache mode is set to Disable.
CacheMode G
•
Enable: Inflow control is set to Enable.
•
Disable: Inflow control is set to Disable.
InflowControl H
• Single: The cross-subsystem paths work in the Single mode.
•
Multi: The cross-subsystem paths work in the Multi mode.
•
APLB: The cross-subsystem paths work in the APLB mode.
PathMode I
Capacity of the external volume. This capacity is expressed in blocks. Capacity J
Extended identification number of the external volume Characteristic2 K
Information about the cross-subsystem paths Third Layer
Identifier + A
+ B
Port number of the local storage system Port C
WWN of the external storage system WWN D
LU number of the external volume LUN E
The information about the external volumes that is defined to the local storage system will be stored
in files per path group. It takes approximately 30 seconds to store the data into files when there
are 64 path groups.
Saving Storage System Information 105