HP StorageWorks XP Remote Web Console Software - Manual (Page 43)

Figure 19 Create V-VOL Dialog Box (1)
Description Item
Shows the V-VOL group ID set in the New V-VOL Group
dialog box V-VOL Group
Select the emulation type. OPEN-V is the only type that is
supported. Emulation Type
Select the capacity unit:
•
MB (megabyte)
• Block
•
Cyl (cylinder)
Capacity Unit
Enter the V-VOL capacity.
• If you selected MB in the Capacity Unit drop-down list,
you can enter numbers from 46 to 4,194,303.
•
If you selected block in the drop-down list, you can enter
numbers from 96,000 to 8,589,934,592.
• If you selected Cyl in the Capacity Unit drop-down list,
you can enter numbers from 50 to 4,473,924.
When you specify the Capacity Unit as MB or Cyl, the
storage system optimally corrects the capacity. Therefore,
to set the capacity accurately to the largest value of the
VDEV capacity, specify the Capacity Unit as block.
Capacity
Enter the number of V-VOLs that you want to add, from 1
to 1,024. See System Option Mode 726, explained
“V-VOLs” (page 10) .
The number of V-VOLs that you can enter in this dialog box
can vary, depending on the number of the V-VOL groups
to be copied in New V-VOL group dialog box (see
“Creating a New V-VOL Group (1)” (page 64) ). For
example, if you specified 100 V-VOL groups in this dialog
box, you can specify 10 V-VOLs per V-VOL group, because
the maximum total is 1,024. In this case, the displayed
range would be 1 to 10.
Number of V-VOL
Adds the V-VOLs to the list Set
Create V-VOL Dialog Box (1) 43