HP Integrated Lights-Out - Manual (Page 76)

Configuring iLO 2 76
If Enable NIC is set to Yes, the diagnostic port is enabled.
• Transceiver Speed Autoselect
• Speed
• Duplex
• IP Address
Use this parameter to assign a static IP address to iLO 2 on your network. By default, the IP address
is assigned by DHCP. By default, the IP address is 192.168.1.1 for all iLO 2 Diagnostic Ports.
• Subnet Mask
o Use the subnet mask parameter to assign the subnet mask for the iLO 2 Diagnostic Port. By
default, the subnet mask is 255.255.255.0 for all iLO 2 Diagnostic Ports.
o The use of the Diagnostic Port is automatically sensed when an active network cable is plugged
in to it. When switching between the diagnostic and back ports, you must allow 90 seconds for
the network switchover to complete before attempting connection through the web browser.
NOTE: The diagnostic port will not switch over if an active Remote Console session or a
firmware update is in progress.