HP Designjet Z3200 PostScript Photo Printer series - Manual (Page 152)

The paper cannot be loaded successfully
● Ensure no paper is loaded.
● Ensure the paper is far enough inside the printer; you should feel the printer grab the paper.
● Do not attempt to straighten the paper during the aligning process, unless instructed to do so by
the front-panel display. The printer automatically attempts to straighten the paper.
● The paper may be crumpled, or warped, or may have irregular edges.
Unsuccessful roll load
● If the paper does not load, the leading edge of the paper may not be straight or clean, and needs
to be trimmed. Remove the initial 2 cm (1 in) from the roll and try again. This may be necessary
even with a new roll of paper.
● Ensure the roll ends are tight against the spindle ends.
● Check that the spindle is correctly inserted.
● Check that the paper is correctly loaded on the spindle, and that it loads over the roll into the printer.
● Check that all roll stops have been removed.
● Check that the paper is wound tightly on the roll.
● Do not touch the roll or paper at during the alignment process.
If the paper has not been inserted straight, the front panel displays the following instructions.
1. When prompted by the front-panel display, lift the blue lever on the left. The printer attempts to
straighten the roll.
2. When prompted by the front-panel display, lower the blue lever. The printer checks the alignment.
If the roll is aligned, the printer measures the width and you are now ready to print.
If the roll is still not aligned, the front panel displays an error and instructions.
3. When prompted by the front-panel display, lift the blue lever on the left.
4. Rewind the roll from the end of the spindle until the edge is on the blue line.
5. Press OK , on the front panel.
6. When prompted by the front-panel display, lower the lever. The printer checks the alignment. If the
roll is aligned, the printer measures the width and you are now ready to print.
If the roll is still not aligned, the front panel displays an error and instructions to start again at step
three.
If you would like to start the load process again, cancel the process on the front panel and rewind
the roll from the end of the spindle until the edge is removed from the printer.
Unsuccessful sheet load
● Guide the sheet, especially thick papers, when the printer initially feeds the sheet.
● Do not attempt to straighten the sheet during the loading process, unless instructed to by the front-
panel display. The printer automatically attempts to straighten the sheet.
● Preferably avoid using hand-cut sheets; if you need to use them, load them with the option Sheet,
without skew check.
142 Chapter 12 Troubleshooting paper issues ENWW
Pa
per is
sue
s