HP LaserJet 2300 Printer series - Manual (Page 40)

38 Chapter 2 Printing tasks ENWW
To load envelopes in tray 1
Many types of envelopes can be printed from tray 1. Up to 10 can be
stacked in the tray.
1 Open tray 1 by pulling the front cover down.
2 Open the rear output bin by pulling down on the top section of the
bin. Slide out the extender until it extends fully.
Note
Using the rear output bin reduces envelope curl.
3 Slide the width guides on tray 1 outward to a position that is slightly
wider than the media.
4 Place the envelopes into the tray short-edge in, print-side up. The
stamp end must enter the printer first.
5 Slide the width guides inward until they lightly touch the envelope
stack without bending it. The envelopes should be centered
between the paper guides and under the tabs on the paper-width
guides.
Note
If the envelope has a flap on the short edge, this edge must enter the
printer first.
You might experience some jams when using any media with a length
less than 178 mm (7 inches). This might be caused by paper that has
been affected by environmental conditions. For optimum performance,
make sure that you are storing and handling the paper correctly (see
“Printing and paper storage environment” on page 138 ). Using media
from another manufacturer might also help.
1
2
3
4
5