Set light/dark and resolution, Set the default light/dark (contrast) setting, Set resolution settings – HP Color LaserJet CM2320 Multifunction Printer series User Manual
Page 137
Set the redial-on-no-answer option
If this option is turned on, the product redials automatically if the receiving machine does not answer.
The factory-set default for the redial-on-no-answer option is Off.
1.
On the control panel, press
Setup
.
2.
Use the arrow buttons to select Fax setup, and then press
OK
.
3.
Use the arrow buttons to select Advanced setup, and then press
OK
.
4.
Use the arrow buttons to select Redial if no answer, and then press
OK
.
5.
Use the arrow buttons to select On or Off, and then press
OK
.
Set the redial-on-communication-error option
If this option is turned on, the product redials automatically if some sort of communication error occurs.
The factory-set default for the redial-on-communication-error option is On.
1.
On the control panel, press
Setup
.
2.
Use the arrow buttons to select Fax setup, and then press
OK
.
3.
Use the arrow buttons to select Advanced setup, and then press
OK
.
4.
Use the arrow buttons to select Redial Comm. Error, and then press
OK
.
5.
Use the arrow buttons to select On or Off, and then press
OK
.
Set light/dark and resolution
Set the default light/dark (contrast) setting
The contrast affects the lightness and darkness of an outgoing fax as it is being sent.
The default light/dark setting is the contrast that is normally applied to items that are being faxed. The
slider is set to the middle as the default setting.
1.
On the control panel, press
Setup
.
2.
Use the arrow buttons to select Fax setup, and then press
OK
.
3.
Use the arrow buttons to select Advanced setup, and then press
OK
.
4.
Use the arrow buttons to select Default lighter/darker, and then press
OK
.
5.
Use the
<
button to move the slider to the left to make the fax lighter than the original, or use the
>
button to move the slider to the right to make the fax darker than the original.
6.
Press
OK
to save the selection.
Set resolution settings
NOTE:
Increasing the resolution increases the fax size. Larger faxes increase the send time and could
exceed the available memory in the product.
The factory-set default resolution setting is Fine.
ENWW
Change fax settings 125