HP Virtual Connect 1.10Gb-F Ethernet Module for c-Class BladeSystem - Manual (Page 43)

Command line 43
Item Description
MonitorPort
(optional)
The server port to be monitored. The format of the monitored port is:
::. If the enclosure ID is not
specified, the default enclosure is the local enclosure.
The ID for the monitor port can be referenced from the ID column in the output of
the show server-port command.
Direction
(optional)
The direction of network traffic on the port being monitored. Valid values include:
"ToServer", "FromServer", and "Both".
Example
->add port-monitor AnalyzerPort=enc0:1:4 Speed=1Gb
Duplex=full MonitorPort=enc0:5:4 Direction=FromServer
Adds a new network analyzer port and a server port to be monitored
Item Description
remove port-monitor Remove ports from a port monitor configuration. Removing the network analyzer
port causes port monitoring to be disabled automatically.
Syntax remove port-monitor AnalyzerPort=
MonitorPort=
Properties
AnalyzerPort The network analyzer port to be removed. "*" removes all the network analyzer
ports from the configuration.
MonitorPort The monitor port to be removed. "*" removes all the monitor ports from the port
monitor configuration.
Examples
->remove port-monitor AnalyzerPort=enc0:3:1
Removes the network analyzer from the configuration
->remove port-monitor monitorPort=enc0:1:1
Removes a specific server port from the monitored port list
->remove port-monitor monitorPort=*
Removes all monitored ports
Item Description
set port-monitor Modify an existing port monitor configuration.
Syntax set port-monitor [Enabled=]
[AnalyzerPort=]
[Speed=]
[Duplex= MonitorPort=]
[Direction=]
Properties
Enabled (optional) Enables or disables port monitoring. The network analyzer port must be
configured properly before port monitoring can be enabled.
AlayzerPort
(optional)
The uplink port used for monitoring network traffic. The format of the network
analyzer port is: ::.
If the enclosure ID is not specified, the default enclosure is the local enclosure.
Speed (optional) The port speed for the network analyzer port Valid values include: "Auto",
"10Mb", "100Mb", "1Gb", and "Disabled". The default value is "Auto".