HP Virtual Connect 1.10Gb-F Ethernet Module for c-Class BladeSystem - Manual (Page 42)

Command line 42
Item Description
->set network Network1 PrefSpeedType=Custom PrefSpeed=4000
MaxSpeedType=Custom MaxSpeed=6000
Modifies network to preferred connection speed of 4Gb and maximum connection
speed of 6Gb
Item Description
show network Display all Ethernet networks in the domain.
Syntax show network [ | *]
Parameter
NetworkName
(optional)
Name of an existing network in the VC domain. "*" displays a detailed view of all
the networks. If not specified, a summary view of the networks is displayed.
Examples
->show network
Displays a summary listing of all networks
->show network *
Displays detailed information for all networks
->show network MyNetwork
Displays detailed information for a specific network
port-monitor
Add a new network analyzer port and other ports to be monitored.
Supported actions: add, remove, set, show
Item Description
add port monitor Add a new network analyzer port and other ports to be monitored.
Syntax add port-monitor AnalyzerPort=
Speed=
Duplex= MonitorPort=
Direction=
Properties
AnalyzerPort
(optional)
The uplink port that is used for monitoring network traffic. Only one port can be
configured as the analyzer port.
After a port has been allocated to port monitoring, it is not available for use in
VC networks and shared uplink sets.
The format of the network analyzer port is
::.
If the enclosure ID is not specified, the default enclosure is the local enclosure
where the domain resides.
Speed (optional) The port speed for the network analyzer port. Valid values include: "Auto",
"10Mb", "100Mb", "1Gb", and "Disabled". The default value is "Auto".
Duplex (optional) The duplex mode of the network analyzer port. Valid values include: "Auto",
"Half", and "Full". The default value is "Auto".