HP Virtual Connect 1.10Gb-F Ethernet Module for c-Class BladeSystem User Manual
Page 28

Command line 28
Item Description
->add fc-connection MyNewProfile Fabric=SAN_5
Adds a new FC SAN fabric connection to a profile
->add fc-connection MyNewProfile Fabric=SomeFabric
Speed=4Gb
Adds a new FC SAN connection and configures the port speed
->add fc-connection MyNewProfile
Adds a new FC SAN connection and uses the next available fabric
->add fc-connection MyNewProfile AddressType=Factory-
Default
Adds a new FC SAN connection and uses factory-default addresses
->add fc-connection MyNewProfile AddressType=User-
Defined PortWWN=50:06:0B:00:00:C2:62:00
NodeWWN=50:06:0B:00:00:c2:62:01
Adds a new FC SAN connection and provides user-defined WWN addresses
Item Description
remove fc-connection
Remove the last FC connection from an existing server profile.
Syntax
remove fc-connection
Parameter
ProfileName (required) The name of an existing profile from which the last FC connection is to be
removed.
Example
->remove fc-connection MyProfile
Removes an FC-connection from a profile
Item Description
set fc-connection
Modify an existing server profile connection.
Syntax
set fc-connection
[Fabric=
[Speed=
[BootPriority=
[BootLun=
Parameters
ProfileName (required) The name of the server profile that contains the connection to modify
Port (required)
The port number of the connection being modified
Properties
Fabric (optional)
The name of the FC SAN fabric to associate with the connection. The fabric
being specified should be associated with the same bay as the FC
connection.
Speed (optional)
The port speed of the FC SAN connection. Valid values include "Auto",
"4Gb", "2Gb", "1Gb", and "Disabled".
BootPriority
(optional)
Controls whether the FC HBA port is enabled for SAN boot and will affect the
BIOS boot order. Valid values include "BIOS", "Primary", "Secondary", and
"Disabled".