HP Virtual Connect 1.10Gb-F Ethernet Module for c-Class BladeSystem User Manual
Page 15

Command line 15
Item Description
delete domain
Delete the existing Virtual Connect domain configuration.
Deleting the domain removes the entire Virtual Connect domain configuration
and resets it to the original defaults. After the domain has been deleted, you are
logged out and the Virtual Connect Manager resets.
Syntax
delete domain [-quiet]
Option
quiet
Suppresses user confirmation prompts. This option is useful when scripting delete
domain operations.
Examples
->delete domain
Deletes the Virtual Connect domain configuration and prompts for user
confirmation
->delete domain -quiet
Deletes the Virtual Connect domain quietly without prompting for user
confirmation (primarily used in automated scripting scenarios)
Item Description
set domain
Modify general Virtual Connect domain configuration properties, such as the
domain name, domain IP address, and MAC and WWN address pool settings.
Syntax
set domain [Name=
[IpAddress=
[Gateway= User-Defined>] [MacPool=<1-64>] [MacStart=
[MacEnd=
] [WwnType=| User-Defined>] [WwnPool=<1-64>] [WwnStart=
[WwnEnd=
Properties
Name(optional)
The new name of the domain. Valid characters include alphanumeric, "_", and
".". The maximum length of the name is 64 characters.
DomainIP (optional) Enables or disables the Virtual Connect domain IP address. If enabled, then a
valid IP address subnet mask must be configured. If disabled, then DHCP is used
to obtain a valid IP address.
Enabling domain IP address configuration or changing the domain IP address
can cause a temporary loss of connectivity to the Virtual Connect Manager. Use
caution when changing these settings. Valid values include "Enabled" and
"Disabled".
IpAddress
(optional)
A valid IP address to use for the domain IP address configuration. The IP address
must be in the format: xxx.xxx.xxx.xxx, where x is a number between 0 and 9.
Example: 192.168.0.10
SubnetMask
(Required if IP
address specified)
A valid subnet mask for the domain IP address configuration. The subnet mask
must be in the format: xxx.xxx.xxx.xxx, where x is a number between 0 and 9.
For example: 255.255.255.0
Gateway (Required
if IP address
specified)
A valid gateway address for the domain IP address configuration. The gateway
address must be in the format: xxx.xxx.xxx.xxx, where x is a number between 0
and 9. For example: 192.168.0.1
MacType (optional) The type of MAC address source to use for assignment. Valid values include "VC-
Defined", "Factory-Default", and "User-Defined".