Expansion board options – HP ProLiant ML110 G2 Server User Manual
Page 42
Hardware options installation 42
5.
Install the DIMM. Refer to the installation sheet for server-specific configuration and population
guidelines.
6.
Replace the access panel ("
" on page
).
Expansion board options
Depending on the model, HP ProLiant 100 Series servers use one of the following methods to retain
expansion boards within the server:
•
A single expansion board retainer for all expansion boards (internal)
•
Individual retainers for each expansion board
•
A single expansion board retainer for all expansion boards (external)
This document provides the following procedures for installing expansion boards into HP ProLiant 100 Series
servers:
•
Installing an expansion board with a single retainer
•
Installing an expansion board with individual retainers
•
Installing an expansion board with an external retainer
For server-specific expansion board installation instructions, refer to the installation sheet that ships with the
server.
Installing an expansion board with a single retainer
CAUTION:
To prevent damage to the server or expansion boards, power down the server and
remove all AC power cords before removing or installing the expansion boards.
To install the component:
1.
Power down the server (on page
2.
Extend the server from the rack, if applicable.
3.
Remove the access panel ("
" on page