HP ProLiant ML110 G2 Server - Manual (Page 41)

Hardware options installation 41
13. Secure the media bay screws.
14. Close the media bay retainers.
Memory options
For server-specific memory installation guidelines, refer to the installation sheet that ships with the server.
Interleaving and non-interleaving memory configuration
This server supports both interleaving and non-interleaving memory configurations. Interleaving memory
increases bandwidth by allowing simultaneous access to more than one block of data (for example,
overlapping Read-Writes). This is accomplished by dividing the system memory between pairs of DIMMs and
Writing-Reading blocks of data to/from both simultaneously. In order to take advantage of memory
interleaving, identical DIMMs must be installed in pairs. DIMMs can also be installed singularly in slot 1 only
if memory interleaving is not desired.
Installing DIMMs
1. Power down the server (on page 6 ).
2. Extend the server from the rack, if applicable.
3. Remove the access panel (" Access panel " on page 11 ).
4. Open the DIMM slot latches.