HP Lights-Out 100 Remote Management User Manual
Page 8
Installation 8
2.
Shut down the operating system as outlined in the operation system instructions.
3.
Power off the server and all the peripherals connected to it.
4.
Unplug all cables from the power outlets to avoid exposure to high energy levels that can cause
burns when parts are short-circuited by metal objects such as tools or jewelry.
5.
Label each cable, if not already labeled, to expedite reassembly.
6.
Disconnect telecommunication cables to avoid exposure to shock hazard from ringing voltages.
7.
Open the server according to the instructions described in your server manual.
Installing the remote management card on ProLiant
ML110 G3 servers
1.
Remove the access panel.
2.
Lay the server on its unexposed side to access the system board.
3.
Locate the remote management card connectors on the system board.
4.
Install the remote management card in the connectors on the system board.
5.
Reinstall the system covers following the "Post-installation procedures (on page