HP Lights-Out 100 Remote Management User Manual
Page 37
Using LO100 37
o
oemhp_nonvol_mask
specifies the subnet mask stored in non-volatile memory.
o
oemhp_gateway specifies the gateway IP address for the NIC. This setting is dynamic.
o
oemhp_nonvol_gateway
specifies the gateway IP address stored in non-volatile memory.
o
oemhp_dhcp_enable
specifies whether DHCP is enabled for the NIC. Boolean values are
accepted
o
oemhp_nonvol_dhcp_enable
specifies whether DHCP is enabled for the NIC and address
stored in non-volatile memory.
Configuring network settings using the BIOS Setup Utility
To enable a static IP address:
1.
Press the F10 key during POST to enter the BIOS Setup Utility.
2.
Press the right arrow (
→
) key to navigate to the Advanced menu.
3.
Press the down arrow (
↓
) key to scroll to IPMI. Press the Enter key.
4.
On the ProLiant ML150 G2 server:
a.
Press the down arrow (
↓
) key to scroll to the LAN Interface submenu. Press the Enter key.
b.
Select IP Address Source, and press the Enter key to toggle between Enabled and Disabled. Set
DHCP IP Source to Disabled.
c.
Press the down arrow (
↓
) key to scroll to the IP Address setting.
d.
Enter a valid IP address. Press the Tab or period (.) key to move between address fields.
e.
Press the down arrow (
↓
) key to scroll down to the Subnet Mask submenu. Press the Enter key.
f.
Enter a valid subnet mask. Press the Tab or period (.) key to move between address fields.
5.
On the ProLiant ML110 G3 server:
a.
Press the down arrow (
↓
) key to scroll to the Set LAN Configuration submenu. Press the Enter key.
b.
Select DHCP IP Source, and press the Enter key to toggle between Enabled and Disabled. Set
DHCP IP Source to Disabled.
c.
Press the down arrow (
↓
) key to scroll to the IP Address submenu. Press the Enter key.
d.
Enter a valid IP address, subnet mask, and gateway address. Press the Tab or period (.) key to
move between address fields.
e.
Press the Esc key to return to the Set LAN Configuration submenu.
f.
Press the down arrow (
↓
) key to scroll to the Subnet Mask submenu. Press the Enter key.
g.
Enter a valid subnet mask. Press the Tab or period (.) key to move between address fields.
6.
On the ProLiant DL140 G2 and ProLiant DL145 G2 servers:
a.
Press the down arrow (
↓
) key to scroll to the LAN Settings submenu. Press the Enter key.
b.
Set the IP Address Assignment to Static. This setting enables you to modify a static IP address
through the BIOS setup menu.
c.
Press the down arrow (
↓
) key to scroll down and enter a valid IP address, subnet mask, and
gateway address (press the Tab or period (.) key to move between address fields).
7.
Press the F10 key to save and exit.
To enable a DHCP assigned address:
1.
Press the F10 key during POST to enter the BIOS Setup Utility.