Installation, Remote management card kit contents, Pre-installation procedures – HP Lights-Out 100 Remote Management User Manual
Page 7
Installation 7
Installation
In this section
Remote management card kit contents ........................................................................................................ 7
Pre-installation procedures......................................................................................................................... 7
Installing the remote management card on ProLiant ML110 G3 servers........................................................... 8
Post-installation procedures........................................................................................................................ 9
Remote management card kit contents
The remote management card kit is required only on ProLiant ML110 G3 and ProLiant ML150 G2 servers.
ProLiant ML110 G3
•
HP ProLiant ML110 G3 Remote Management Card
•
Spacer support
•
HP Lights-Out 100 Remote Management Card Installation Instructions for HP ProLiant ML110
Generation 3 Servers
ProLiant ML150 G2
•
HP ProLiant ML150 G2 Remote Management Card
•
Hexnut screw
•
HP Lights-Out 100 Remote Management Card Installation Instructions for HP ProLiant ML150
Generation 2 Servers
Pre-installation procedures
The installation procedures in this document are intended for individuals who are qualified in the servicing
of computer equipment and trained in recognizing hazards in products with hazardous energy levels.
WARNING:
Failure to properly turn off the server before you open the server may cause
serious damage to the equipment as well as bodily harm.
CAUTION:
Follow the ESD precautions listed in your server guide when handling the remote
management card.
IMPORTANT:
Observe the pre- and post-configuration procedures described in later sections
when installing the remote management card.
NOTE:
The procedures described in this section assume that the server is positioned on a flat,
stable surface.
1.
Back up the server data.