HP Lights-Out 100 Remote Management - Manual (Page 23)

• The cd command sets the current default target. The context works similar to a directory
path. The root context for the server and the starting point for a CLP system is /. (forward
slash period). By changing the context, you can shorten commands.
For example:
— The cd command changes the directory.
— The cd .. command moves up the tree one directory.
— The cd myfolder command moves to the myfolder folder if myfolder is in the
current directory.
• The show command displays values of a property or contents of a collection target. For
example:
/./> show
/.
Targets
system1
map1
Properties
Verbs
cd
version
exit
show
help
The first line of information returned by the show command is the current context. In the
example,
/.
is the current context. Following the context is a list of subtargets (Targets) and properties
(Properties) applicable to the current context. The verbs section (Verbs) shows which
commands are available in this context.
The show command can also be specified with an explicit or implicit context and a specific
property. An explicit context is /map1/firmware and is not dependent on the current
context. An implicit context assumes that the context specified is a child of the current context.
If the current context is /map1, then a show firmware command displays the
/map1/firmware data. If a property is not specified, then all properties are shown.
• The load command moves a binary image from a URL to the map. The load command is
used to take a binary image from a specific source location (specified as a URL) and place
it at the specified target address. In a remote management processor implementation, the
firmware downloads a full image file using TFTP from the specified location and programs
flash with the image.
In a remote management processor implementation, /map1/firmware is a valid target.
The load command supports usage only with the following options.
— -source — This option must be specified.
— (h)elp — This option appears on the command line. The command ignores all options
and properties except -output (for terse or verbose output). These options are only
valid for this command when the -help option is used.
source — This option specifies the target from which to transfer the binary
image. The value specified must be a valid URL. The format is //tftpserverip/
path/filename
. This option is required in the command line when the load command
is executed unless -help is used. The file must be an uncompressed firmware image
file that you create using the DOS ROMPAQ utility found on the Lights-Out 100
Using CLP 23