HP 3PAR Recovery Manager Software for VMware vSphere Licenses - Manual (Page 65)

RMExch peer
SYNTAX
RMExch peer [[]|[-clear]|[-bs ]]
DESCRIPTION
The RMExch peer command configures the peer backup servers for two HP 3PAR Storage System
CCR configurations. The backup server executes all commands and sends certain commands to
the peer backup server to run (such as create and backup) for the passive node option. Once the
configuration is set, you will not need to run this command again unless you want to change the
peer relationship between the backup servers.
PARAMETERS
The following options are supported:
•
-bs - The server's name you would like to designate as your peer backup
server.
•
-display - Used if the -bs parameter is not used. Displays the current configuration of your
peer backup servers.
•
-clear - To remove the peer relationship between backup servers. Once the peer relationship
is removed, both backup servers are no long able to manage CCR nodes.
NOTE: The RMExch peer command is intended only for CCR configuration. The -bs option
only needs to be run once to set up the peer relationship and to manage the CCR configuration.
Examples
The following command will configure the peer backup server .
RMExch peer -bs server1
Recovery Manager Commands 65