HP 3PAR Recovery Manager Software for VMware vSphere Licenses - Manual (Page 64)

RMExch mount
SYNTAX
RMExch mount -s -g -t
-h [-mp “mountpoint”] | [-domain ]
DESCRIPTION
The RMExch mount command mounts a virtual copy created by the RMExch create command.
When using RMExch mount command to mount a virtual copy, the program will check to see if
the virtual copy is already mounted to a host machine. The virtual copy must have an “Available”
status, before it can be mounted
PARAMETERS
The following options are supported:
•
-s - The name of the Exchange server for which the storage group
belongs.
•
-g - The name of the storage group for which the virtual copy timestamp
belongs.
•
-t - The timestamp of the virtual copy to mount.
•
-h - Windows host name to mount the virtual copy. The target host must have
recovery manager installed.
If you are using a multiple domain configuration and the Windows host is not in the local
domain, use the -h option to specify the fully qualified domain name (FQDN) of the host’s
domain.
•
-mp "mountpoint" - Optional - Quotation enclosed mount point, if you prefer to mount the
volume(s) elsewhere besides default directory. Full path is required. Default is to mount to
:\3parsnapshot
.
•
-domain - Optional. Specifies the domain to which the Exchange server
or storage group belongs.
If this option is not specified, Recovery Manager uses the local domain.
NOTE: Use quotes ("") where spaces are included.
NOTE: The is the host name defined in the HP 3PAR Storage System. Available
host names defined in the system can be listed by executing the HP 3PAR InForm CLI showhost
command.
NOTE: The -expose option was deprecated in release 3.1.1.
Examples
The following command will mount the virtual copy 020405162103 to the directory d:\Rmmount.
RMExch mount -s bottlenosed -g sg2 -t 020405162103 -h bottlenosed -mp
"d:\RMmount"
64 Using the Recovery Manager CLI