ADTRAN Express XRT - Manual (Page 52)

Chapter 4. Application Configuration
38 Express XRT User Guide 61202.153L3-1
The Express XRT can be reset to the factory default settings by set-
ting switch 2 to the Off (up) position. See the section Verify Switch
Settings on page 5 for more information.
Profile Configurations
Some common configurations are preset in the Express XRT soft-
ware as profiles. Most Internet service providers supporting
ISDN also support PPP protocol. If connecting to an Internet ser-
vice provider using one B-channel, select Factory: PPP 64k (Inter-
net),
which sets the protocol to PPP. If arrangements have been
made with the Internet service provider to use two B-channels, se-
lect Factory: Multilink PPP 128k (Internet), which uses multilink
PPP protocol.
Loading a factory profile has no effect on any ISDN Phone Num-
ber(s) or Switch Type settings already configured. The settings
that are altered when applying a profile are shown as follows:
Factory: PPP 64k (Internet)
Factory: Multilink PPP 128k (Internet)
DTR Options Ignore DTR
Flow Control Hardware Flow
Protocol Fallback
Call Type Data 64kbps
Auto Answer Enabled
DTR Options Ignore DTR
Flow Control Hardware
Protocol Type PPP
PPP Mode Single-link PPP
Call Type Data 64kbps
Auto Answer Enabled
DTR Options Ignore DTR
Flow Control Hardware
Protocol Type PPP
PPP Mode Multilink PPP