ADTRAN Express XRT - Manual (Page 23)

Chapter 2. Installation
61202.153L3-1 Express XRT User Guide 9
6. Insert the disk labeled Windows 95 and Windows NT into the
3.5" floppy disk drive.
7. Click OK.
8. Select ADTRAN Express XRT from the Drivers list.
9. Click NEXT.
10.Choose the COM port to which the Express XRT is attached
from the list of available COM ports.
11.Click NEXT.
12.Continue the installation by providing country, area code, and
outside line access information as prompted.
13.Click NEXT.
14.Click Finish to complete the modem installation process.
15.Select Close.
16.Go to the next section.
Express Configuration Wizard Installation for Microsoft
Windows 95 and Windows NT 4.0
The Express Configuration Wizard is a graphical user interface
which allows you to configure and test the Express XRT with ease.
Follow the installation procedure that applies to the operating
system.
1. From the Start button, choose Settings, then Control Panel,
then double click Add/Remove Programs.
2. From the Install/Uninstall tab, select the Install button.
3. Insert the disk labeled Windows 95 and Windows NT.
4. Click NEXT.
5. If the disk is found, click Finish; otherwise use Browse to first
locate the disk. The Express Configuration Wizard begins in-
stallation.
6. Follow the step-by-step screen instructions throughout the in-
stallation process. Two options are available for installation
during the Express Configuration Wizard installation: Express
Configuration Program
and INF Files. Figure 2-3 on page 10
illustrates the two options.