ADTRAN Express XRT - Manual (Page 51)

61202.153L3-1 Express XRT User Guide 37
Chapter 4
Application Configuration
There are three methods available for configuring the Express
XRT: Express Configuration Wizard, VT 100 terminal, or AT
Commands.
Before configuring the Express XRT for any application, the Ex-
press XRT should be connected correctly for the application as de-
scribed in the chapter Installation on page 5.
Some features in the Express XRT do not take effect upon selec-
tion. This prevents unintentional reconfiguration of the Express
XRT during an active call. Items such as Bit Rate, Protocol, and
Call Type take effect only at the beginning of a new call.
Technical notes, documents and scripts can be found on the ADT-
RAN web home page at http://www.adtran.com under the Infor-
mation Desk
. These provide information on how to use
ADTRAN products in specific applications on PC and Macintosh
platforms.
FACTORY DEFAULT CONFIGURATION
The Express XRT is shipped configured as follows:
Auto-Detect SPIDs/Switch Disabled
Switch Type Euro ISDN
Call Type Data 64K
Auto Answer Enabled
Call Screening Answer Any
Call Routing Speech/Audio calls to POTS