ADTRAN Express XRT User Manual
Page 22
Chapter 2. Installation
8
Express XRT User Guide
61202.153L3-1
Microsoft Windows 95 and Windows NT 4.0
Windows 95 Plug and Play
1. During the Windows 95 boot process, if the
New Hardware
Found
screen appears indicating
ADTRAN Express XRT
, se-
lect
Driver from disk provided by hardware manufacturer
. If
the Windows 95
New Hardware Found
screen does not ap-
pear, skip the rest of this section and go to
Windows 95/Windows
NT 4.0 Control Panel Modem Installation
on page 8.
2. Insert the disk labeled
Windows 95 and Windows NT
into the
3.5" floppy disk drive.
3. Click
OK
. The
Install From Disk
screen should appear.
4. Click
OK
or use
Browse
to locate the correct disk drive.
5. Select
ADTRAN Express XRT
from the
Drivers
list.
6. Click
OK
. Windows installs the INF file and a modem labeled
ADTRAN XRT
on the COM port to which the unit is connect-
ed.
7. Check for the device. From
Star
t, choose
Settings
, then
Con-
trol Panel
, then double click
Modems
.
8. The ADTRAN Express XRT should be listed under the General
tab in the
Modems Properties
dialog box.
9. Click
OK
.
10.Click
Close
.
11.Go to
Express Configuration Wizard Installation for Microsoft Win-
dows 95 and Windows NT 4.0
on page 9.
Windows 95/Windows NT 4.0 Control Panel Modem In-
stallation
For Windows NT 4.0, you must be a member of the Administrator
Group
to install a new modem.
1. From the Start button, choose Settings, then choose Control
Panel
, then double click Modems.
2. If a modem has not been installed on the computer previously,
the modem installation process begins immediately. From this
menu, choose Add to begin installation of the Express XRT.
3. In the Install New Modem dialog box, check Don't detect my
modem; I will select it from a list
.
4. Click NEXT.
5. Click the Have Disk button.