Avaya 3600 - Manual (Page 53)

Avaya, Inc. Configuration and Administration—AVAYA 3616/3620/3626 WT
Avaya CCMS IP, Avaya Call Server, with Avaya 4612 IP Telephone Emulation
21-300352, Issue 2, July 2005 Page 53
13.3 Wireless Telephone Status Messages
Wireless Telephone status messages provide information about the 3600 Series Wireless Telephone’s
communication with the AP and host telephone system. The following table summarizes the status
messages, in alphabetical order.
Message Description Action
3 chirps WT is not able to communicate with
the best AP, probably because that
AP has no bandwidth available. None. This is only a warning, the
call will handoff to the best AP
once it becomes available.
Address Mismatch WT software download files are
incorrect or corrupted Download new software from the
OEM site per Software
Maintenance.
ASSERT xxx c
Line yyy The WT has detected a fault from
which it cannot recover. Record the error code so it can be
reported.
Turn the WT off then on again.
If error persists, try registering a
different WT to this telephone port.
If error still persists, contact OEM
Technical Support and report the
error.
Assoc Failed
xxxxxxxxxxxx x…x = AP MAC address
WT association was refused by AP;
displays MAC of failing AP. Check WT and AP security
settings.
Ensure AP is configured per
Configuration Note.
Try another AP.
Assoc Timeout
xxxxxxxxxxxx x…x = AP MAC address
WT did not receive association
response from AP; displays MAC of
failing AP Check WT and AP security
settings.
Ensure AP is configured per
Configuration Note.
Try another AP.
Auth Failed
xxxxxxxxxxxx x…x = AP MAC address
WT authentication was refused by
AP; displays MAC of failing AP Check WT and AP security
settings.
Ensure AP is configured per
Configuration Note.
Try another AP.
Auth Timeout
xxxxxxxxxxxx x…x = AP MAC address
WT did not receive authentication
response from AP; displays MAC of
failing AP Check WT and AP security
settings.
Ensure AP is configured per
Configuration Note.
Try another AP.
Bad Code Type xx
Expected Code
Type yy xx, yy = software license types
WT software does not match current
handset license selection Download new software from the
OEM site per Software
Maintenance.
Bad Config Some needed configuration
parameter has not been set Check all required WT
configuration parameters for valid
settings
Bad ESSID The WT is configured for “static
ESSID” (as opposed to “Learn once”
or “Learn always” and no ESS ID
has been entered. Enter an ESSID in the
configuration settings or change to
one of the “Learn” modes.