Avaya 3600 - Manual (Page 25)

Avaya, Inc. Configuration and Administration—AVAYA 3616/3620/3626 WT
Avaya CCMS IP, Avaya Call Server, with Avaya 4612 IP Telephone Emulation
21-300352, Issue 2, July 2005 Page 25
either
Passphrase
and enter a passphrase between eight and 63 characters in length or
Direct
Entry
and enter the 256-bit key code.
WPA2-PSK:
The security features of WPA2 (Wi-Fi Protected Access) using PSK (Pre-Shared
Key) are available and may be used if supported by the access points in the facility. Select
either
Passphrase
and enter a passphrase between eight and 63 characters in length or
Direct
Entry
and enter the 256-bit key code.
Consult the Configuration Note for the access points (APs) installed in
your facility for information on which of the WPA versions are
recommended by Avaya engineering. Configure the recommended
version on the AP and select the corresponding option on the Admin
menu.
Regulatory Domain
The Regulatory Domain will default to
None
on the Wireless Telephone display. FCC
requirements dictate that the menu for changing the domain be available by password, which in
our case is the
LINE
key. To change the domain, press
LINE
and then enter the digits that
represent the site’s domain. Note that both digits must be entered.
01
- North America
02
- Europe (except Spain and France); Japan (channels 1-13)
04
- Spain
05
– France
As of this writing, Spain and France are adopting the general European
Regulatory rules. Check with your wireless LAN administrator or
supplier for which domain to enter in these countries.
Transmit Power
Available transmit power is regulated by domain. The Regulatory Domain setting above affects
the options available for this setting. The default setting is
Maximum
which in North America is
100 mW. The Maximum in other domains is 30 mW. Transmit Power may be set to a lower
number if necessary by selecting one of the other levels. If changed from the default, ensure the
Transmit Power setting is the same on all Wireless Telephones and all APs.
Diagnostics
Run Site Survey
The Site Survey mode is activated by selecting this option. Site survey starts running
immediately upon selecting this option. See the Diagnostic Tools section for more information
about Site Survey.
Diagnostics Mode
See the Diagnostic Tools section for a detailed explanation of the Diagnostics Mode options.
Syslog Mode
See the Diagnostic Tools section for a detailed explanation of the Diagnostics Mode options.
Restore Defaults
The Restore Defaults option will set all user and administrative parameters to their factory defaults.