Canon FAXPHONE L100 - Manual (Page 80)

80
Error Code Cause Action
#099
A user canceled a job that is
processing to be sent or received.
Try to send or receive the document again.
#995
A document waiting to be sent or
received has been canceled by a
user.
Try to send or receive the document again.
Improve Output Quality
Follow the recommended actions for each symptom to improve the output quality.
If you cannot solve the problem with the following actions, see
[Troubleshooting] in the e-Manual.
Symptom Example Action
Paper curls
•
Verify that the appropriate paper is being used (
→
p.18).
•
Print a test page with new paper.
•
Verify that the paper is loaded properly (
→
p.18).
Paper creases
•
Verify that the appropriate paper is being used (
→
p.18).
•
Print a test page with new paper.
•
Verify that the paper is loaded properly (
→
p.18).
•
Remove any foreign objects inside the machine.
•
Change the <Special Mode D> setting from the operation panel.
Printing is uneven
•
Verify that the appropriate paper is being used (
→
p.18).
•
Print a test page with new paper.
•
Verify that the paper is loaded properly (
→
p.18).
•
Check the toner level (
→
p.67).
White specks appear
•
Verify that the appropriate paper is being used (
→
p.18).
•
Print a test page with new paper.
•
Check the toner level (
→
p.67).
•
If printing high-contrast documents from a computer, open the
printer driver and select [Finishing]  [Advanced Settings] 
[Special Print Mode]  [Special Settings 2] to adjust the density.
The toner adheres to
the hand
•
Verify that the appropriate paper is being used (
→
p.18).
•
Print a test page with new paper.
The printed paper has
vertical streaks
•
Verify that the appropriate paper is being used (
→
p.18).
•
Print a test page with new paper.
•
If the machine is not in use for a long after the toner cartridge has
been replaced, change the <Special Mode C> settings from the
operation panel.
•
When printing received faxes or reports, change the <Special
Mode B> settings from the operation panel.
•
When printing, change the [Special Print Adjustment] settings
from the printer driver.