Canon VB-C60 - Manual (Page 94)

2-28
Preset Setting Tool
5. Click [Apply].
Check the status list to make sure the settings have been applied correctly, and then click the
[Save preset settings] button to save the settings in the camera.
Note
z The preview based on the panorama preview function may vary slightly from the actual
image. After setting a preset, be sure to confirm with Admin Viewer that the preset has
been reflected correctly.
z To apply the manual focus mode, manually adjust the focus while checking the actual
image using Admin Viewer. After the focus has been adjusted, set the focus using the [Get
value] button. You can save the focus value using the [Save preset settings] button.
z If the image stabilizer setting is changed after a preset has been set, the set viewing angle
will no longer agree with the viewing angle during operation ( P. 3-22). If the image
stabilizer setting has been changed, check the preset settings again.
z If a dome housing is used, be sure to set presets with the dome installed.
z If the camera mounting method has been changed, set presets again.
Tip
z Up to 20 presets can be set.
z Changes to preset settings are not reflected in the connected viewer.
z You can disable presets in VB-C60 Viewer by selecting the [Not shown in viewers] ( P. 2-
24) check box.
z Preset positions cannot be set in the digital zoom area.
z You can also set multiple presets and save them all at once using the [Save preset settings]
button.