Brother DCP-9045CDN - Manual (Page 96)

82
Change Parts
PF Kit MP
It is time to replace the paper
feeding kit for the MP tray. Call your Brother dealer to purchase the
PF Kit MP.
Change Parts
PF Kit 1
It is time to replace the paper
feeding kit for Tray 1. Call your Brother dealer Service to purchase
the PF Kit 1.
Change Parts
PF Kit 2
It is time to replace the paper
feeding kit for Tray 2. Call your Brother dealer Service to purchase
the PF Kit 2.
Change Parts
Waste Toner Box
The waste toner box is almost full. Be ready to replace the waste toner box. (See
Replacing the waste toner box on page 134.)
Check Paper Size The paper in the tray is not the
correct size.
Load the correct size of paper in the tray and
set the "Paper Size" (Menu, 1, 2) and "Tray
Use" (Menu, 1, 6). (See Paper size on
page 21, Tray use in copy mode on page 22
and Tray use in print mode on page 22.)
Cooling Down
Wait for a while The temperature of the drum unit
or toner cartridge is too hot. The
machine will pause its current
print job and go into cooling down
mode. During the cooling down
mode, you will hear the cooling
fan running while the LCD shows
Cooling Down, and
Wait for a while. Make sure that you can hear the fan in the
machine spinning and that the exhaust outlet
isn't blocked.
If the fan is spinning, remove any obstacles
that surround the exhaust outlet, and then
leave the machine turned on but do not use it
for several minutes.
If the fan is not spinning follow the suggestions
below.
Turn off the machine's power switch and then
turn it on again. If the error message continues
leave the machine for several minutes and
then try it again.
Cover is Open
Close the Front
Cover. The front cover is not closed
completely. Close the front cover of the machine.
Cover is Open
Close the Back
Cover. The back cover is not closed
completely. Close the back cover of the machine.
Document Jam The document was not inserted
or fed properly, or the document
scanned from the ADF was too
long. See Document jams on page 86 or Using the
ADF (automatic document feeder) on
page 19.
Drum Error The corona wires on the drum
unit need to be cleaned. Clean the four corona wires on the drum unit.
(See Cleaning the corona wires on page 104.)
EL Error The machine has a mechanical
problem. Open the front cover and close it again.
Fuser Error The temperature of fuser unit
does not rise at a specified
temperature within specified time. Turn the power switch off, wait a few seconds,
and then turn it on again. Leave the machine
for 15 minutes with the power on.
The fuser unit is too hot.
Error Message Cause Action