Brother DCP-9045CDN - Manual (Page 161)

Troubleshooting and routine maintenance
147
C
o
Note
We recommend you repack the machine
on a table or desk.
Put the styrofoam piece marked
“FRONT” (1) into the lower carton (3), so
that the arrow cutout (4) points toward it.
Put the styrofoam piece marked “REAR”
into the lower carton so that the arrow
cutout (4) points away from it.
p
Using two people, place the machine
into the plastic bag and then into the
lower carton, matching the “FRONT”
piece to the front of the machine as
shown in the illustration in Step o.
q
As shown in the illustration, fit the two
foam pieces marked “FRONT” (4) to the
cardboard piece marked “FRONT” (7).
Fit the “REAR/L” (5) and “REAR/R” (6)
foam pieces to the left and right of the
cardboard piece marked “REAR” (8).
r
Put the assembled “FRONT” (1) and
“REAR” (2) cardboard pieces in the
lower carton at the front and rear of the
machine as shown in the illustration.
The foam pads should fit closely to the
machine to support it.
s
Place the upper carton (1) over the
machine and the lower carton. Match
the joint holes (2) of the upper carton to
the joint holes (3) of the lower carton.
3
2
1
4
4 8
7
6
5
1
2
2
1