Brother ADS-1000W - Manual (Page 24)

Configuring Your Machine for a Wireless Network
21
3
(ADS-1000W/ADS-1100W)
a Using a small, pointed object, press the AOSS/WPS Button on the back of the machine for about 15
seconds.
NOTE
The machine will beep after the button is pressed for two seconds. Continue to press the button.
b Using a computer connected to the network, type "http://access point's IP address/" into your browser
(where "access point's IP address" is the IP address of the device that is used as the Registrar
1 ).
1 The Registrar is normally the WLAN access point/router.
c Go to the WPS setting page, type the PIN indicated on the label at the bottom of the machine into the
Registrar, and follow the on-screen instructions.
NOTE
The setting page is different, depending on the brand of access point/router you are using. See the
instruction manual supplied with your access point/router.
Windows Vista
®
/Windows
®
7/Windows
®
8
3
If you are using your computer as a Registrar, follow these steps:
NOTE
• To use a Windows Vista
®
, Windows
®
7, or Windows
®
8 computer as a Registrar, you need to register it
to your network in advance. See the instruction manual that came with your WLAN access point/router.
• If you use Windows
®
7 or Windows
®
8 as a Registrar, you can install the scanner driver after the wireless
configuration by following the on-screen instructions. If you want to install the full driver and software
package, follow the steps in the Quick Setup Guide for installation.
1 (Windows Vista
®
)
Click (Start) > Network > Add a wireless device.
(Windows
®
7)
Click (Start) > Devices and Printers > Add a device.