Brother MFC-9420CN - Manual (Page 163)

Chapter C
C - 38
4
Remove the transfer belt cover.
5
Remove the transfer belt cleaner by
grasping the handle and lifting it up.
6
Clean the area where the new transfer
belt cleaner is to be installed with a dry
cotton cloth.
7
Put the new transfer belt cleaner into the
machine by gently placing the brass
bearings into the guides, and then
pushing the handle down until the
bearings click into place. Make sure the
transfer belt cleaner is free to move
slightly upwards (rotating slightly around
the bearings) in the housing after you
have installed it.
8
Put the transfer belt cleaner cover back
in, and then close the top cover.
9
Close the inside cover, and then close
the scanner unit.
0
Turn the machine’s power switch back
on.