Brother MFC-3100C - Manual (Page 84)

9 - 4 R E M O T E F A X O P T I O N S ( N O T A V A I L A B L E F O R C O L O R F A X )
BHLMFC-US-MFC3100C-FM5.5
Remote Commands
Follow the commands below to access features remotely. When you call the
MFC and enter your Remote Retrieval Access Code (1 5 9 ), the system will
signal you with two short beeps to enter a remote command.
Remote Commands Operation Details
95 Change Fax Forwarding
/Paging setting
1 OFF If you hear one long beep, the change is accepted. If you hear three
short beeps, you cannot change it because the conditions have not
been met (Example: registering paging number). You can register
your fax forwarding number by using 4. FAX FWD NO. (see page
9-5). Once you have registered the number, the MFC will change
automatically to FAX FWD:ON mode.
2 Fax Forwarding
3 Paging
4 FAX FWD No.
6 Fax Storage ON You can turn FAX STORAGE to ON or OFF.
7 Fax Storage OFF
96 Retrieve a fax
2 Retrieve all faxes Enter the number of a remote fax machine to receive stored fax
message(s). (See page 9-5.)
3 Erase fax from the memory If you hear one long beep, you can erase fax message(s) from the
memory.
97 Check the Receiving Status
1 FAX You can check whether your MFC has received any faxes . If yes,
you will hear one long beep. If no, you will hear three short beeps.
98 Change Receive Mode
1 EXT.TEL/TAD If you hear one long beep, you can change the Receive Mode.
If you hear three short beeps, you cannot change it.
2 FAX ONLY
90 Exit After a long beep, you can exit remote retrieval.