TOHO ELECTRONICS TTM-509 - Manual (Page 17)

TOHO TOHO ELECTRONICS INC.
DWG. No.
45-4199-E
PAGE
17/66
Bank setting mode
Press the MODE key
for 3 seconds.
Press the MODE key
for 3 seconds.
Press the MODE key
for 3 seconds.
CH key

 
MODE key
Bank 0
Set the SV on CH1.

 
MODE key
Bank 7
Set the SV on CH1.

 
Bank 0
Set the SV on CH2.
 
  Bank 0
Select the control
setting.
The following flow is the same
as that for the control setting.
Press the MODE key
for 3 seconds.
CH key

 
Bank 7
Set the SV on CH2.
 
  Bank 7
Select the control
setting.
The following flow is the same
as that for the control setting.
Operation mode
Press the MODE key for 6
seconds. The system will
display another screen once.
But hold the key down.
While in the operation mode, press the MODE key for 3 seconds. The system will then switch to
the "Select the setting mode" screen. But hold the key down for a total of 6 seconds or more until
the system switches to the bank setting mode. The bank setting mode comes in the SV setting
mode and the control selection setting mode.
(1) SV setting mode
This mode allows the SVs on banks 0 to 7 to be set.
(2) Control selection setting mode
Select a bank and press the MODE key to enter the "control selection mode." The method of
setting is the same as in the usual control setting mode (to be described later).