beautypg.com

Starting the engine (6-cylinder models) – Acura 2010 TSX User Manual

Page 371

background image

Your vehicle’s starting system has an
auto control mode. When you turn
the ignition switch to the START
(III) position, this feature keeps the
engine’s starter motor running until
the engine starts. Follow these
instructions to start the engine:

Without touching the accelerator
pedal, turn the ignition switch to
the START (III) position, then
release the ignition switch. You do
not need to hold the ignition
switch in the START (III) position
to start the engine. Depending on
the outside temperature, the
starter motor runs for about 6 to 9

seconds until the engine starts.

Make sure the shift lever is in
Park. Press on the brake pedal.

In cold weather, turn off all
electrical accessories to reduce
the drain on the battery.

Apply the parking brake.

If the engine does not start, wait at
least 10 seconds before trying
again.

If you hold the ignition switch in
the START (III) position for more
than 7 seconds, the starter motor,
depending on the outside
temperature, runs for about 10 to
25 seconds until the engine starts.

1.

2.

3.

4.

Starting the Engine (6-cylinder models)

368

The immobilizer system protects your
vehicle f rom thef t. If an improperly
coded key (or other device) is used, the
engine’s f uel system is disabled. For
more inf ormation, see page

.

The engine is harder to start in cold
weather. Also, the thinner air f ound at
altitudes above 8,000 f eet (2,400
meters) adds to this problem.

121

2010 TSX

This manual is related to the following products: