Acura 2010 TSX - Manual (Page 238)

Dolby
PL (ProLogic) II signal processing
creates multi-channel surround
sound from 2 channel stereo audio
sources. Dolby ProLogic II can only
be activated when listening to DISC
(CD-DA, MP3/WMA), XM Radio,
and AUX. When ProLogic II is active,
‘‘PL II’’ is shown in the audio display.
The SVC mode controls the volume
based on vehicle speed. The faster
you go, the louder the audio volume
becomes. As you slow down, the
audio volume decreases.
The SVC has four modes: SVC OFF,
SVC LOW, SVC MID, and SVC
HIGH. The default setting is MID.
To change the SVC mode, select
SVC, then press ENTER on the
interface selector. The current
setting is shown on the screen. Turn
the interface knob to the desired
level, and enter your selection by
pressing ENTER on the interface
selector. If you feel the sound is too
loud, choose low. If you feel the
sound is too quiet, choose high.
To set this feature on or off, select
Dolby PL II, and press ENTER on
the interface selector. Rotate the
interface dial to ON or OFF, and
press ENTER.
Manufactured under license from
Dolby Laboratories. ‘‘Dolby’’,
‘‘ProLogic’’, and the double-D symbol
are trademarks of Dolby
Laboratories.
In some audio playing modes
(XM, AUX), when DPLII is on, the
music coming from the rear
speakers may sound distorted. This
is due to compression of the music,
and it does not indicate a problem
with the setting.
Dolby PL (ProLogic) II Speed-sensitive Volume
Compensation (SVC)
Playing the FM/AM Radio (Models with navigation system)
Fe
a
tu
re
s
235
NOTE:
2010 TSX