Acura 2010 TSX - Manual (Page 131)

Avoid dropping or throwing the
transmitter.
Protect the transmitter from
extreme temperature.
Do not immerse the transmitter in
any liquid.
If you lose a transmitter, the
replacement needs to be
reprogrammed by your dealer.
If it takes several pushes on the
button to lock or unlock the doors,
replace the battery as soon as
possible.
Battery type: CR1616
Separate the keypad from the
transmitter by pushing any button
from outside.
Be careful when removing
this screw as the head of the screw
can strip out.
Remove the screw at the base of
the transmitter with a small
Phillips-head screwdriver.
To replace the battery:
To turn the memory position link
settings back on, repeat this
procedure. The LED will blink once
to indicate the feature has been
turned on.
You can turn off this driving position
memory activation. Press and hold
the LOCK and UNLOCK buttons at
the same time. The LED in the
remote transmitter will blink twice.
Then release the buttons. Doing this
also cancels the memory position
link setting for that remote and
restores the default settings.
You will also see the ‘‘DRIVER 1’’ or
‘‘DRIVER 2’’ message on the multi-
information display, depending on
which linked remote transmitter is
used.
1.
2.
Remote Transmitter
Remote Transmitter Care
Replacing the Transmitter
Battery
128
NOTE:
KEYPAD SCREW
2010 TSX