Acura 2010 TSX - Manual (Page 221)

Press the AUX button with the
ignition switch in the ACCESSORY
(I) or ON (II) position. The audio
display shows the
Audio
message and mark. Until the phone
is recognized, you will see ‘‘NO
CONNECT’’ on the display. This
message will go off when the phone
is recognized, then the system
begins to play.
After a device is linked, press the
TITLE button to confirm the device
name. The name of the device will
appear on the audio display.
If more than one phone is paired to
the HFL system, there will be delay
before the system begins to play.
To begin to play the audio files, you
may need to operate your phone. If
so, follow the phone maker’s
operating instructions.
If an iPod, USB flash memory
device, or audio unit connected
to the auxiliary input jack was
selected at the last mode, you
will see iPod, USB, or AUX in
the audio display. Push the AUX
button again to play audio files
from your
Audio
phone.
Your vehicle is equipped with a
Audio system, which
allows you to listen to streaming
audio from your
Audio
compatible phone. This function is
only available on phones that are
paired and linked to the vehicle’s
HandsFreeLink (HFL)
system (see page ).
Make sure that your phone is paired
and linked to HFL.
Not all Bluetooth-enabled phones
with streaming audio capabilities are
compatible with the system. You can
find an approved phone by visiting
, or by
calling the HandsFreeLink
consumer support at 1-888-528-7876.
In Canada, visit
, or call
1-888-9-ACURA-9.
In some states, it may be
illegal to perform some data device
functions while driving.
:
311
Bluetooth
Bluetooth
Bluetooth
Bluetooth
Bluetooth
www.acura.com/handsfreelink
www.acura.ca
Bluetooth Audio System (Models without navigation system)
To Play Audio Files Bluetooth
218
NOTE:
2010 TSX