Acura 2010 TSX - Manual (Page 229)

Push the interface selector down to
scroll down the screen, highlight
A.SEL, then press ENTER on the
interface selector. You will see
A.SEL flashing on the screen, and
the system goes into scan mode for
several seconds.
Use the tune, skip (seek), scan, or
RDS function to tune the radio to a
desired station.
Press the preset button, and hold
it until you hear a beep. You can
also store frequencies with the
interface dial. Select the preset
icon you want to store the
frequency on, then press ENTER
on the interface selector, and hold
it for more than 2 seconds.
Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM.
When the system finds a strong
signal, it will stop and play that
station for about 10 seconds. If you
do nothing, the system will then scan
for the next strong station and play it
for 10 seconds. When it plays a
station that you want to listen to,
press the scan side of the bar again,
or push the interface selector to the
right again.
Each preset button or
preset icon can store one frequency
on AM and two frequencies on FM.
Select the desired band, AM or
FM. FM1 and FM2 let you store
two sets of FM frequencies with
the preset buttons (on-screen
icons).
If you are
traveling and can no longer receive
your preset stations, you can use the
auto select feature to find stations in
the local area.
2.
3.
4.
1.
To store a preset memory location:
Playing the FM/AM Radio (Models with navigation system)
Preset
AUTO SELECT
226
A.SEL INDICATOR
PRESET ICON
A.SEL ICON
2010 TSX