ROTRONIC MBW 373 - Manual (Page 43)

39
Precooler Control
Syntax Function
PreCoolerPID.on[=i][?]
1 ÆPrecooler On, 0ÆOff
PreCoolerPID.setPt? Current Precooler temp setpoint, °C
PreCoolerPID.fixedSetPt[=n][?] Setpoint for fixed mode control, °C
PreCoolerPID.deltaSetPt[=n][?] Setpoint for delta mode control, °C
PreCoolerPID.fixedOn[=i][?] 1 Æfixed mode control enabled, 0Ædisabled
PreCoolerPID.deltaOn[=i][?] 1 Ædelta mode control enabled, 0Ædisabled
SavePID=373 Save these and other PID parameters
Analog Outputs
See Analog Outputs on page 21 for explanation of the parameters.
Syntax Function
Ana1.param[=i][?]
Parameter to track with analog output #1
Ana1.paramMin[=n][?] Min Value
Ana1.paramMax[=n][?] Max Value
Ana1.OutMin[=n][?] Min Voltage
Ana1.OutMax[=n][?] Max Voltage
Ana1.calGain[=n][?] Gain calibration factor for D/A converter
Ana1.calZero[=n][?] Zero calibration factor for D/A converter
Ana1.output=n Use to set analog output when calibrating D/A
converter. Automatically sets Ana1.hold=1. You
must send Ana1.hold=0 when finished with
calibration.
Ana1.hold[=i][?] 1 ÆCalibration mode. Analog output is set with the
command Ana1.output=n.
0
ÆNormal mode. Analog output tracks the
parameter set with Ana1.param=i.
SaveCfg=373 Save these and other configuration parameters
Ana2.param[=i][?] Parameter to track with analog output #2
Ana2.paramMin[=n][?] Min Value
Ana2.paramMax[=n][?] Max Value
Ana2.OutMin[=n][?] Min Voltage
Ana2.OutMax[=n][?] Max Voltage
Ana2.calGain[=n][?] Gain calibration factor for D/A converter
Ana2.calZero[=n][?] Zero calibration factor for D/A converter
Ana2.output=n Use to set analog output when calibrating D/A
converter. Automatically sets Ana2.hold=1. You
must send Ana2.hold=0 when finished with
calibration.
Ana2.hold[=i][?] 1 ÆCalibration mode. Analog output is set with the
command Ana2.output=n.
0
ÆNormal mode. Analog output tracks the
parameter set with Ana2.param=i.
SaveCfg=373 Save these and other configuration parameters