NORD Drivesystems BU0070 - Manual (Page 16)

NORDAC InterBus Operating Manual
16 Subject to technical alterations BU 0070 GB
Parameter Setting value / Description / Note Available in Option
P509 Source control word
0 ... 9
[ 0 ]
valid for SK 5xxE
Selection of the interface via which the FI is controlled.
0 = Control terminals or keyboard control ** with the Control Box (when P510=0), the
Parameter Box (not ext. p-box) or via Bus I/O Bits.
1 = Only control terminals *, the FI can only be controlled via the digital and analog inputs or
via the Bus I/O Bits.
2 = USS control word *, the control signals (enable, rotation direction, etc.) are transferred via
the RS485 interface, the setpoint via the analog input or the fixed frequencies.
3 = CAN control word *
4 = Profibus control word *
5 = InterBus control word *
6 = CANopen control word *
7 = DeviceNet control word *
8 = reserved
9 = CAN Broadcast *
*) Keyboard control (ControlBox, ParameterBox) is blocked, parameterisation is still possible.
**) If the communication during keyboard control is interrupted (time out 0.5 sec), the FI will block
without an error message.
P510 ... - 01
... - 02 Setpoint source
0 ... 8
[ 0 ]
valid for SK 5xxE
Selection of the setpoint source to be parameterised.
[01] = Master setpoint value source [02] =
Master setpoint value source
Selection of the interface via which the FI receives the setpoint.
0 = Auto: The source of the auxiliary setpoint is
automatically derived from the setting in the
parameter P509 >Interface<
1 = Control terminals, digital and analog inputs
control the frequency, including fixed frequencies
2 = USS
3 = CAN
4 =
Profibus
5 =
InterBus
6 =
CANopen
7 =
DeviceNet
8 =
reserved