NORD Drivesystems MI0700 - Manual (Page 57)

3 Power and control terminal connection
MI 0700 GB-0414 57
SK 700E
Name
Function
[factory setting]
SK 5xxE
Customer unit
SK CU1-MLT
Part No.
Connector
Terminal No.
Name
Terminal strip
Terminal No.
Name
SK 5xxE
onboard
Part No.
DIP left
Analogue input 1
DIP
top
ON = current
OFF = voltage
[Default = OFF]
Activatable 250 Ω
load resistor for
0 /
4…20 mA
left = I (current)
right = V (volt.)
[Default = V] DIP
right DIP
bottom
Analogue input 2
* Meaning see table / page 54.
**
The setpoint converter ±10 V (278910320) is only needed for sizes 1 to 4 (1.5 kW to 7.5 kW) of all SK 5xxE frequency
inverters. In case of applications with frequency inverters ≥ size 5 and ±10 V signals at the analogue inputs, only SK 54xE
types of frequency inverters should be used.
***
The IO extension SK EBIOE- 2 (275900210) can be used to connect the 2nd analogue output (0…10 V) and the two
analogue inputs (-10 V…+10 V). Thus, additional ±10 V setpoint converters (278910320) are not needed. The IO extension
SK EBIOE-2 can only be connected to SK 540E and SK 545E frequency inverters. For more information, refer to the
Technical Information TI 275900210 (see www.nord.com ).
**** Terminal X7: 26 / DIN6 is available on ≥SK 520E frequency inverters only.
***** Terminal X5: 41 / VO 5V is not available on SK 540E frequency inverters and on SK 545E frequency inverters ≥ size 5 only.
Table 36: Customer unit Multi I/O, SK CU1-MLT