11 additional information, 1 maintenance and servicing information, 2 abbreviations in this manual – NORD Drivesystems BU0230 User Manual
Page 74: Repairs, Internet information
Functional safety with NORD SK 200E frequency inverters
74
BU 0230 GB-2712
11 Additional information
11.1 Maintenance and servicing information
In normal use, NORDAC SK 200E frequency inverters are maintenance free. Please also refer to the "General
Data" in manual BU 0200 GB.
If the frequency converter is being used in a dusty environment, the cooling-vane surfaces should be regularly
cleaned with compressed air. If air intake filters have been built into the control cabinet, then these should also
be regularly cleaned or replaced.
If you contact our technical support, please have the precise device type (rating plate/display), accessories
and/or options, the software version used (P707) and the series number (name plate) at hand.
Repairs
The device must be sent to the following address if it needs repairing:
NORD Electronic DRIVESYSTEMS GmbH
Tjüchkampstr. 37
26605 Aurich, Germany
For queries about repairs, please contact:
Getriebebau NORD GmbH & Co. KG
Tel.: 04532 / 289-2515
Fax: 04532 / 289-2555
If a frequency inverter or accessories are sent in for repair, no liability can be accepted for any added
components, e.g. such as line cables, potentiometer, external displays, etc.!
Please remove all non-original parts from the frequency inverter.
NOTE
If possible, the reason for returning the component/device should be stated. If necessary, at
least one contact for queries should be stated.
This is important in order to keep repair times as short and efficient as possible.
On request you can obtain a suitable goods return voucher from Getriebebau NORD
GmbH.
Internet information
You can also find the comprehensive manual in German and in English on our Internet site.
11.2 Abbreviations in this manual
AS-i ..... AS interface
BW ...... Brake resistor
EMC ..... Electromagnetic compatibility
FI .........
Frequency inverter
OSSD .. Output Signal Switching Device
S ........... Supervisor Parameter, P003
SH ......... "Safe stop"
SS1 ....... safe stop 1
STO ....... safe torque off
SW ....... Software version, P707