Milestone XProtect Express 2014 - Manual (Page 87)

Milestone XProtect ® Express 2014 Administrator's Manual
www.milestonesys.com 87 Advanced configuration

Live Frame Rate - used when speeding up recordings in connection with motion detection or
similar functionality.

FPS (Frames per second) - used for the additional stream used for live viewing.
Regular frame rate mode:
Properties available for all XProtect software versions:
Name Description
Frame Rate
Required average frame rate for video from the camera. Select
number of frames, then select the time unit interval (second, minute
or hour).
Properties available in XProtect Enterprise and XProtect Professional only:
Live Frame Rate
Required average frame rate for live video from the camera. Select
number of frames, then select the time unit interval (second, minute
or hour).
If the camera supports dual stream and dual stream is enabled, the
Live Frame Rate column will be read-only with the value Dual
streaming
—which cannot be altered.
Recording Frame Rate
Required average frame rate for recorded video from the camera.
Select number of frames, then select the time unit interval (second,
minute or hour). The frame rate must be higher than the frame rate
specified under normal mode.
Speedup frame rate mode:
Properties available in all XProtect software versions:
Name Description
Enable speedup frame rate
The speedup feature lets you use a higher than normal frame rate if
motion is detected and/or an event occurs. When you enable
speedup, further columns for specifying speedup details become
available.
Frame Rate
Speedup frame rate for viewing video from the camera. Select
number of frames, then select the time unit interval (second, minute
or hour). The frame rate must be higher than the frame rate
specified under normal mode.
On motion
Select this check box to use the speedup frame rates when motion
is detected. The camera will return to the normal frame rates two
seconds after the last motion is detected.