beautypg.com

Detector settings, Recorded message, Detection logging – Hoyles CELLPHONE DETECTOR Plus 610 User Manual

Page 6

background image

Detector Settings

The 'Settings' tab in the Utilities Software can be used to:

Give the detector a unique text identifier.

Turn Red LED Flashing On/Off.

Turn Alert Beeps On/Off and set the Beep Count.

Turn playing of the Record Message On/Off.

Turn off the Detectors speaker and only play audio through the Audio Out port.

Pause further detection for up to 60 minutes after an Alert has played.

Recorded Message

The steps to change a voice message are:

Get a good quality message. You can download one from a set of standard messages off the
website or you can use your own. To record one you can use a PC sound card, or to generate
a synthesized one you could use a text to speech program (e.g. AT&T Natural Voice). Save the
message in uncompressed .wav file format.

Connect the Cellphone Detector to the PC with the USB cable, and run the Cellphone Detector
utilities program.

From the download messages tab select your new file to load.

Press upload and the message will be automatically processed and uploaded. Note, depending on
the PC used this may take over 60 seconds. Follow any on screen messages.

Detection Logging

The detector can record a log of up to 10,000 detections instead of storing a Recorded Message.
This may be enabled in the 'logging' tab, which will erase the recorded message and start a log that
may be downloaded, viewed, and exported to a spreadsheet CSV file at any time.
The logging signal strength is an approximate measurement of the strength of signal when it reaches
the detector. It is inversely proportional to the sensitivity slider for the respective channel.

A weak signal (e.g. a strength of 10%) will only be detected if it's slider is raised to over 90%

A strong signal (e.g. a strength of 90%) will still be detected if it's slider is only just over 10%

n.b. Removing power from the detector (i.e. taking out the batteries or unplugging an external power
source) will erase the log. A new blank log will be started when the detector recieves power again.

6