Hoyles Stop n Search random employee search selector - Manual

s
s
s
s s
s
s
s
STOP
STOP
STOP
STOP
STOP
STOP
STOP
STOP
Single flash
every 2 seconds
Single flash
every 2 seconds
Single flash
every 2 seconds
Single flash
every 2 seconds
Double flash
every 2 seconds
Double flash
every 2 seconds
Double flash
every 2 seconds
Double flash
every 2 seconds
Range 1 Range 2
4 Move jumper J1 from position B to position A.
4 The indication on the front panel indicates the current setting.
4 Repeatedly press the PROG button to change selection rate for
that range.
4 Press the front panel button to change ranges. When changing
ranges, the unit single bleeps for Range 1 and double bleeps for
Range 2.
4 Once the required rate is displayed, move the jumper J1 back to
position B. The unit sounds the ‘Whoop Whoo’ tone and is ready to
use with the new selection rate.
2 %
5 %
10 %
20 %
30 %
50 %
70 %
90 %
4 Connect the mains supply to the terminals in the backbox.
4 When first powered the all indicators illuminate and the buzzer bleeps twice to demonstrate
that all is well.
4 The factory default selection rate is 20%. However the unit has an Non Volatile Memory
(NVM) to store the latest selection rate even if power is lost.
4 Press the panel button to start selection.
4 A green indication with a ’Whoop Whoo’, tone indicates not selected.
4 Both red STOP indicators with a pulsed alarm tone indicates selected. This indication must be
reset with the key.
Stop ‘n’ Search TAG3 Installation Instructions
DWG No 60088 Jul 13
To set the selection rate, (the percentage of people to be searched)
P
R
O
G
A
-
B
+ START
J1
N/C
COM
N/O
N/C
COM
N/O
ZO
RT
DC
X ZO
T. 01744 886600 F. 01744 886607 E. [email protected] W. www.hoyles.com
Hoyles Electronic Developments Ltd