FUTEK IPM52x (D520) Digital Display - Manual (Page 6)

5
SECTION 2
SECTION 2.0 SAFETY SUMMARY
All safety related regulations; local codes and instructions that appear in this
literature or on equipment must be observed to ensure personal safety and to prevent
damage to either the instrument or equipment connected to it. If equipment is used in a
manner not specified by the manufacture, the protection provided by the equipment may be
impaired.
Do not use this unit directly command motors, valves, or other actuators not
equipped with safeguards. To do so can be potentially harmful to persons or equipment in
the event of a fault to the unit.
The unit must be properly grounded. Ground connection is tied to the Main Board “P1”
connector pin C.
Fuse replacement must be performed with power disconnected. Use only the same type
fuse. The fuse must be a TR5 microfuse, Time Lag (T), 1 amp, 250VAC. Fuse location
shown in section 1.3
CAUTION: Read complete CAUTION: Risk of Electric shock
Instructions prior to installation
And operation of the unit.